Error message with Flow trigger: There’s a problem with the flow’s trigger

Like (0) Share

Report

Posted on 24 Jul 2019 04:53:29 by Community Power Pla...

When I went into Microsoft Flow today, to check one of my Team Flows, it showed an error message:

'There is a problem with the flow's trigger.'

When I clicked 'Fix the trigger', it showed a 'BadGateway' message.

MOC flow picture 1.png MOC flow picture 2.png MOC flow picture 3.png MOC flow picture 4.PNG

However, when I went into the Flow to check, the trigger looked normal, and the Flow Checker showed 0 errors and 0warnings.

MOC flow picture 5.png MOC flow picture 6.png

When I saved and exited, it seemed ok, but then a minute later the 'There is a problem with the flow's trigger' message appeared again.

I don't understand why I am now seeing this error.

The flow ran correctly only a few weeks ago.

Hope someone can explain what is going on to me, and how to fix it so that the flow will run when I next need it (within 2 weeks time).

Many thanks,

Best regards,

Adam Bradbury

All responses (3)

Answers (1)

Verified answer

Brad_Groux 4,556 on 31 Jan 2020 at 05:23:02

Like (1)

Report

Re: Error message with Flow trigger: There’s a problem with the flow’s trigger

@ericonline wrote:

I'm facing this issue today. The Flow was delayed by 4-5 mins. When checking the runs, I see the "fix the trigger" error. The Flow eventually runs, but this is disheartening. Please advise.
Thank you

500, 501 and 502 errors are temporary/transient errors that generally indicate connectivity issues or "blips" in service, and are usually cleared after a short amount of time.

Periodically there are connectivity and/or network issues between the various Office 365 services that cause these type of errors. If the errors persist, you'll need to Contact Flow Support directly for assistance.

👨🏻‍💻 If this reply answers your question or solves your issue, please ACCEPT AS SOLUTION ☑️. If you find this reply helpful, please consider giving it a LIKE 👍.
Community Power Pla... on 21 Jan 2020 at 16:06:12

Like (0)

Report

Re: Error message with Flow trigger: There’s a problem with the flow’s trigger

I'm facing this issue today. The Flow was delayed by 4-5 mins. When checking the runs, I see the "fix the trigger" error. The Flow eventually runs, but this is disheartening. Please advise.
Thank you
v-bacao-msft on 25 Jul 2019 at 01:51:49

Like (0)

Report
Re: Error message with Flow trigger: There’s a problem with the flow’s trigger

Hi @Anonymous ,

This seems to be a temporary error since your configuration is no problem.

Please try to solve this problem by using the following two methods.

Reconfigure the trigger's connection and see if a similar issue still exists.

Or you could click Save as to create a copy of this Flow. A copy of Flow will appear in My flows list. You could check if the Flow has a similar problem. If not, share it with Team users.

Hope it helps.

Best Regards,