You’re offline. This is a read only version of the page.
42
I have a custom connector that makes an HTTP call. When I call it via a PowerApp, it calls the Custom Connector multiple times - usually four times.
I want to only call it once.
I'm wondering if this is a timeout issue - sometimes it can take up to 30 seconds for the receiving server to respond with the sending information.
Thoughts?
How do you set retry parameters in a PowerApp?
I know how to do this in a flow, but I don't want to retool our entire custom connector interface to go through flows for each possible command, as this defeats the purpose of a custom connector.
#1
WarrenBelz
770
Most Valuable Professional
#2
stampcoin
494
#3
MS.Ragavendar
399
Share
Report
All responses (
Answers (
