How i can add a new parallel process and link it to exsisting action

(0) Share

Report

Posted on by johnjohn123

3,514

i have 3 parallel actions linked to a single action after they are executed, as follow:-

but now i need to add a 4th parallel action >> but when i did so i am unable to link it to the next action (i marked the missing link in red).. any advice?

Categories:

Building flows

I have the same question (0)

All responses (3)

Answers (0)

Sort by

Pstork1 69,475 Most Valuable Professional on at

Like (0)

Report
Copy link

Link copied!

I think this is just a temporary issue in the editor. Save the flow and re-open to see if the line appears. You can't have a parallel action that doesn't come back into the flow so it has to link to something. That's why I think its just an editor issue.

Was this reply helpful? Yes No
johnjohn123 3,514 on at

Like (0)

Report
Copy link

Link copied!

@Pstork1i saved the MS flow>> close the Ms Flow >> reopen it again.. but still the last parallel action does not have any line linked to the next action..

Was this reply helpful? Yes No
Pstork1 69,475 Most Valuable Professional on at

Like (0)

Report
Copy link

Link copied!

Does the next item in the flow have any Run After settings set? You might look at those and make sure the Run after setting is pointing to the 4th parallel action. If not you will need to remove and re-add the 4th parallel branch to get it to show in the Configure Run after settings.

Was this reply helpful? Yes No