Announcements
Hello - I have a power automate flow based on a stored proc. We added a new parameter to the proc. How do we refresh Power Automate to recognize this? Do not see any 'refresh' button or ability to do that.
Thanks,
Dan
Hi @lesotho_kid ,
I would like to suggest the option of removing the action and then re-adding it as a potential solution.
Best Regards,
Bof
Thanks @v-bofeng-msft will do. Though this is obviously insanely inefficient to do - we have quite a few parameters - so taking time to rebuild whenever there is a change seems like a waste. Seems like Microsoft should add a refresh button?!
Under review
Thank you for your reply! To ensure a great experience for everyone, your content is awaiting approval by our Community Managers. Please check back later.
Congratulations to our community stars!
Expanding mentorship, skilling, and AI innovation
These are the community rock stars!
Stay up to date on forum activity by subscribing.
Mohsin Ali 355
11manish 336 Super User 2026 Season 2
M Bilal Khan 308
