@IMathur
A trigger filter is designed to allow the trigger to run/fire only when an expression used in the filter evaluates to true.
I usually create my trigger filters in two steps. First I add a condition to my Flow and enter the expression that I'll use in the filter. This makes it easy for me to create the expression because I do it in the expression editor and can pick values from Dynamic properties. Click on the link below to see a video showing how I created my condition. My condition evaluates to true when the Project status is complete.
Link to video 1
After I add the condition, I run my Flow to make sure that my expression operates properly.
After testing, I copy the expression to my clipboard. Then I go to the settings for the trigger and click to add a filter. The filters all start with an @ so I enter the @ and then paste the expression. Then I can remove the condition.
Link to video 2
Once you add a trigger condition, you no longer need a condition in your Flow as it will only run when the Project Status is Complete.
Please let me know if you have additional questions.