Unanswered

Flow Stop running next steps

(0) Share

Report

Posted on by PHAMDANG

Hi everybody,

I am building the Multi cases approval Process, my flow is using the Variable Status to set it was Approver 1 or Approver 2 or Approver 3 based on the Approval Matrix. However, sometimes it run done in Approver 1 and set Successful but it should come to next Approver.

Another question is when I change the current flow, will previous run can continue or it will be stopped.

Best regards,

Categories:

Building flows

I have the same question (0)

All responses (3)

Answers (0)

PrasadAthalye on at

Like (1)

Report

Re: Flow Stop running next steps

Previous run continues when you change the flow. Can you put more details as to what is the issue on approvals? Its not clear from following...

sometimes it run done in Approver 1 and set Successful but it should come to next Approver.

Was this reply helpful? Yes No
v-litu-msft on at

Like (0)

Report

Re: Flow Stop running next steps

Hi @PHAMDANG,

Could you please share screenshots of your Flow configuration? It could help us assist you better.

Best Regards,
Community Support Team _ Lin Tu
If this post helps, then please consider Accept it as the solution to help the other members find it more quickly.

Was this reply helpful? Yes No
PHAMDANG 5 on at

Like (0)

Report

Re: Flow Stop running next steps

Hello guys,

I currently used the Set Variable Status for the state of Process. And use do until.

My Process is 1st pass to Stage "ChargeJobPE" then "ChargeJobCase". However, some ran smoothly but some done at 1st stage and Flow said is was successful.

Was this reply helpful? Yes No