You’re offline. This is a read only version of the page.
Announcements
59
I am a little further than my last posting by now.
I am making a Flow that should RE-CREATE AND COMPLETE any Planner Card generated on one Plan (Client Relations) and then on its corresponding Group (MA, MAAF, AFI).
I have almost got it.
My issue is that 'update a task' to Complete the Task on the second Plan.
I am using an Apply to Each bucket to do something funky, and this may be my issue.
Essentially, based on a variable in D365 (MA, MAAF, AFI), it will go down one of three paths. I have only built one for now.
It is funny, because the filter will find the correct task (in this case, at least...)
(Block - test task - completed is the one I am looking for!)
SO, it appears that the Flow failed, AND that the task was Completed, AND that is actually was not completed on its Planner Plan.
Any insight before I beat my head into a wall tomorrow?
Please & Thank you.
Did you ever figure this out? Trying to figure out if this same thing is possible and your flows would be a great blueprint
Share
Report
All responses (
Answers (
