Response ID is not available to select

(0) Share

Report

Posted on by GF-02121351-0

239

Hi,

I cannot figure out what I am doing wrong. I created my form, went to go setup the flow to take the data and put it in a Dataverse table, but I cannot select Response ID.

Screenshot 2024-03-04 100526.png

Categories:

Building flows

I have the same question (0)

All responses (2)

Answers (1)

Verified answer

Nived_Nambiar 18,129 Super User 2025 Season 2 on at

Like (1)

Report

Re: Response ID is not available to select

Hi @gfeldhake

The dynamic content currently shown in above screenshot is response id of form but that is in format of a list, when used an apply to each loop will wrap around the get response details action. If you need to prevent that enable split on option in trigger settings

and then see it should appear like this -

Hope it helps !

Thanks & Regards,
Nived N 🚀

LinkedIn: Nived N's LinkedIn
YouTube: Nived N's YouTube Channel

🔍 Found my answer helpful? Please consider marking it as the solution!
Your appreciation keeps me motivated. Thank you! 🙌

Was this reply helpful? Yes No
GF-02121351-0 239 on at

Like (1)

Report

Re: Response ID is not available to select

That worked, thank you so much!

Was this reply helpful? Yes No