Hi,
I’m having an issue with a Power Automate flow that was working correctly until the end of March.
Currently, the flow is failing with over 173 error messages related to invalid parameters. What’s unusual is that some of these parameters appear in actions where I did not configure them, and they were not part of the original action schema before.
I attempted to fix the issue by editing individual actions, but the experience is unstable. After a short time (approximately 2 minutes), the page crashes with an “Out of Memory” error, which prevents further troubleshooting.
To isolate the problem, I also tried rebuilding the flow from scratch and splitting it into multiple smaller child flows. However, the same issue occurs consistently - after adding approximately the 10th step, the flow starts throwing invalid parameters errors again, followed by the page crashing.
I have been dealing with this issue since Easter, and it is significantly blocking my work.
Summary of the issue:
- Flow was functioning without errors until end of March
- Now returns 173+ “invalid parameters” errors
- Unexpected parameters appear in actions (not configured and not previously present)
- Editing the flow leads to page crash with “Out of Memory” error
- Rebuilding the flow and splitting into child flows does not resolve the issue (errors reappear after ~10 steps)
This essentially makes the flow unusable at the moment. Has anyone experienced something similar or is aware of any recent backend changes or schema updates that could be causing this behavior? Any advice on how to restore or recover a stable version of the flow would be greatly appreciated.
