Hi,
I have created two flows (images below) that are triggered by a condition on two different column values each. once triggered an email is sent. however, an email is sent for both flows when I only trigger one flow.
I wonder if someone could advise on this?
Hi @benjamin856 ,
Are you updating one column to "Completed", where the other one was previously "Completed"? If so, based on what you have above, I would expect both flows to trigger. It doesn't say "only run if this is your first time Completed", it just says "if it satisfies the condition of being completed."
I also can't see where you are using the information from "Get Changes" - can you tell us a bit about that?
Thank you,
Rhia
Share
Report
All responses (
Answers (
8,692
